Superior Stucco Acrylic Finish
SUPERIOR STUCCO ACRYLIC FINISH is manufactured with a pure acrylic emulsion binder with the highest-grade aggregates. Special proprietary additive produces an outstanding flexible finish. It is a Non Toxic, Antimicrobial Finish with High Dirt Pick-up Resistance ( High DPR).
BASIC USES :
SUPERIOR STUCCO ACRYLIC FINISH is designed for interior and exterior finish coating with freestyle texture over a number of substrates. SUPERIOR STUCCO ACRYLIC FINISH can be applied by hand or by sprayer.
Take care that all surfaces to be covered are free of loose debris, dirt, oil, efflorescence, curing agent, cleaning solutions and foreign matter. Ensure that all surfaces are smooth and free of any irregularities. Pressure washing, mechanical sanding, scrapping, chipping or sandblasting may accomplish smoothing and cleaning the surface. Glossy or smooth surfaces must be roughened to ensure a proper bond. It’s very important to ensure the surface has been properly prepared. DO NOT apply SUPERIOR STUCCO ACRYLIC FINISH until surface is free of all contaminates.
√ Apply SUPERIOR STUCCO ACRYLIC PRIMER, (may be rolled or sprayed).
√ Apply a uniform coat of SUPERIOR STUCCO ACRYLIC FINISH, no thicker than the largest aggregate, to the substrate
√ Immediately following the applicator, use a plastic float or stainless steel trowel in a consistent motion to obtain the desired finish.
*Tilt up or poured in place concrete using bond breaking agents, needs to be approved by Stucco Supply .
- See color bottle for mixing instructions.
- Stucco Supply’s SUPERIOR STUCCO ACRYLIC FINISH must be thoroughly mixed immediately prior to use.
- If multiple pails are being used, intermix pails to achieve consistency.
Stucco Supply’s SUPERIOR STUCCO ACRYLIC FINISH is white and may be colored using Superior Stucco Color Tinting System . Stucco Supply offers 30 different standard colors on request.
AREA OF USE :
SUPERIOR STUCCO ACRYLIC FINISH may be applied to:
- Brown Coat
- Poured-in-place and/or tilt-up concrete
SUPERIOR STUCCO ACRYLIC FINISH should be fully cured in no less than 24 hours. Curing time will vary due to surface temperature, porosity, ambient temperature and/or application method.
Protect applied product from inclement weather until fully dried. DO NOT APPLY SUPERIOR STUCCO ACRYLIC FINISH when the temperature is below 40-Degrees F. or above 100-Degrees F. This range of temperature must be kept for 48 hours to ensure proper curing.
SUPERIOR STUCCO ACRYLIC FINISH should be stored in a cool, dry place out of direct sunlight and other possible damage. Keep SUPERIOR STUCCO ACRYLIC FINISH above 40-Degrees F. and below 100-Degrees F.
CLEAN-UP : Clean up can be done with water immediately after use.
The above statement, recommendation, suggestions and technical data are based on the best knowledge to Stucco Supply and is given as information only, without any responsibility for their use. Stucco Supply makes no warranties or guarantees to this product, either expressed or implied with respect to merchantability or fitness for particular use of said product. Handling and use of product are out of the control of Stucco Supply, so no warranty is given.