Call for an Estimate!

Superior Stucco Star Glue

Adhesive for Expanded Polystyrene (EPS) Insulation Foam Board or Shapes
100% Pure Emulsion Acrylic Bonder with High-Grade Aggregates

Download Superior Stucco Star Glue Spec Sheet


SUPERIOR STUCCO STAR GLUE is intended to be field mixed with Type I-II Portland Cement meeting or exceeding ASTM C150. SUPERIOR STUCCO STAR GLUE can be used to adhere EPS board or shapes (with reinforcing mesh) as well as used as a base coat over EPS board and as a Leveling Coat over approved substrates.


SUPERIOR STUCCO STAR GLUE should be mixed thoroughly with a Heavy Duty Drill & Mix paddle (not to exceed 500 RPM) Pour half of mixed SUPERIOR STUCCO STAR GLUE into a second clean bucket and add equal parts of Type I-II Portland Cement (1:1 mix ratio) and mix for approximately 3-5 minutes. Allow SUPERIOR STUCCO STAR GLUE to take its’ initial set after mixing (few mins). Re-temper/mix to a smooth creamy consistency; clean potable water may be added for workability. DO NOT OVERMIX.


Apply SUPERIOR STUCCO STAR GLUE to back of EPS Insulation Board with notched trowel. Press Insulation Board onto approved substrate. Allow SUPERIOR STUCCO STAR GLUE to set for a minimum of 24 hours prior to working on the EPS Insulation Board. SUPERIOR STUCCO STAR GLUE as a Base Coat over EPS Insulation Board should be applied a minimum of 1/16” (3.2mm) thick to completely embed Reinforcing Mesh into wet base coat. Be sure to trowel smooth, with no mesh showing. SUPERIOR STUCCO STAR GLUE as a Leveling Agent can be applied to the area needed to be leveled after following mixing directions. Additional clean potable water may need to be added to create the proper mixture. Application method will vary due to job conditions. Protect from inclement weather until cured.


The coverage of the SUPERIOR STUCCO STAR GLUE will vary due to job conditions, method of application, and weather conditions. Typically (1) Gallon of most of the SUPERIOR STUCCO STAR GLUE will cover approximately 220 ft. as an Adhesive and 180 ft. as a Base Coat. Yields will vary depending on dilution rate and porosity of substrate.


The SUPERIOR STUCCO STAR GLUE should be stored in a cool, dry place out of direct sunlight. Keep above 40 degrees F and below 110 degrees F.


Do not apply SUPERIOR STUCCO STAR GLUE when the temperature is below 40 degrees F or above 100 degrees F. This range of temperature must be kept for 48 hours to ensure proper curing. Keep away from hydrostatic pressure (Moisture/water) after applying SUPERIOR STUCCO STAR GLUE. Do not apply until surface is free of all contaminates. Please refer to the individual SUPERIOR STUCCO product for detailed information.


Clean up with water immediately. DO NOT ALLOW TO DRY BEFORE CLEAN UP.


The above statement, recommendation, suggestions and technical data are based on the best knowledge to Stucco Supply and is given as information only, without any responsibility for their use. Stucco Supply makes no warranties or guarantees to this product, either expressed or implied with respect to merchantability or fitness for particular use of said product. Handling and use of product are out of the control of Stucco Supply, so no warranty is given.

Request a Quote

Get the Stucco product that is right for you.

What Sets Us Apart

  • Since 1955
  • Family Owned Business
  • Custom Orders Available
  • Delivery to Most Job Sites
  • Contractor's Pricing for All
  • Leading Stucco Manufacturer
  • Highest in Quality and Service